Getting a little off-topic, but I have seen non-zero gaps work well, which made no sense to me - the brim is clearly attached, there is no actual gap. I’ve concluded that Brim-object gap should probably be called Brim-object offset. It controls how well the nearest line of the brim squishes into the object. (similar to how z-offset controls squish on the plate, but horizontally)
Zero offset spaces the line the same as any other line on the bottom surface of the model.
Increasing offset (“gap”) moves the nozzle a bit further away from the object, causing less squish between object and brim, and a weaker bond. Easier removal but less holding power.
The only time there is an actual gap between object and brim is when the offset exceeds half the line width, though the holding power of the brim is probably ineffective long before that point.
I only decrease Brim-object gap if a brim breaks loose from the object while printing. I sometimes experiment with increased gap to make removal easier, with less scarring. Unless I’m printing multiples, it is not normally worth adjusting.