Prime Tower Knocked Down - This is not an adhesion problem

[jetpad]

Here’s a good reply from another thread. I feel like it applies to your situation. Maybe you are over extruding a bit too much?

@hotellonely

A huge difference on H2D against other printers is that it’s using a… servo motor for extruder. This means that when it faces higher than normal backpressure (e.g., warp blocked the nozzle), this extruder will push harder to make sure it can reach the extrusion assigned from the GCODE. Meanwhile, for other nozzles, if there’s a warp that blocked the nozzle slightly, the extruder would not increase its power, it usually end up with a skip instead.