Printing alignment shifts midway through

[Stu]

This is curious, indeed.

I don’t have any experience with this particular problem but someone else has posted a layer shift concern.

Check this out…

Layer shift after first layer...with Pics

I’m getting a layer shift after the first layer on all my prints. First print was the benchy from the Bambu folder on the printer and it looked great but had what looked like a brim on half of the print. When i looked at the bottom that when I noticed the second layer shifted. I re-calibrated and tried again with the same results. I loaded up my own project in the slicer and same thing happened. I have even removed the Bambu from the table I had it on n put it on a more sturdy surface, re-ca…

Good luck,

Stu