I have the same issue. Brand new X2D with 30h of print time.
After manual bed levelling and auto-calibration from printer menu:
After rotating plate 180° (don’t mind the bits at the top edge, it just printed outside the plate).
I should note that I did not run the bed calibration from the printer menu. It only did the auto-bed levelling at the start of the print (what’s the difference?).
Has anyone else tried printing a 1-layer sheet successfully? This feels like a firmware issue to me. Nothing seems to be loose.
The only slightly odd thing I noticed is that I have a bit of plastic squeaking when the Z axis moves, but it’s minor.
I have contacted support and they suggested to do the manual levelling, plus a bunch of things that shouldn’t be relevant: increasing nozzle/bed temperature, reducing print speed, flow calibration. Temperatures and speeds are set by Bambu and everything including the filament is their own hardware. The first layer is just a bunch of lines extruded at constant speed, so I don’t see what flow rate has to do with it.
It can’t be a filament issue because I first noticed the problem on the first layer on a different roll of filament. And if it was, it would happen at random spots.



