Problem with poop / waste disposal postion

Bambu Lab P1 Series
1

Hi,

for some time now, my P1P no longer delivers the waste material (poop) in the correct position.
It has slipped out of position: slightly to the left and too much towards the print bed.
So the waste material does not fall into the waste chute. In most cases, the material collects at the edge of the waste chute, but sometimes it splashes the material between the waste chute and the print bed.

is there a chance to calibrate the position for the “poop”?

Best regard
Ronny

1 Like
2

Have you tried re-running printer calibration?

3

I tried this little mod. I did it in red just so i could if it was still in place. Fixed my problem like yours.

https://www.printables.com/model/419659-bambu-lab-x1-carbon-poop-chute-door-top-extension-

2 Likes
4

escelente rocomendación, aun sigo sin creer que con tan solo esa modificación se corrigiera ese problema. Gracias