Sorry but I am totally confused by your ask. Please help me understand.
Please allow me to restate what I think you are telling me. I’ll also try to answer the questions were relevant. Some of your statements are in conflict with each other:
- You are printing using offline LAN and want to monitor your printer, which is located in another room.
- You have to press play every few minutes to keep the viewing active.
-
- What kind of device are you pressing play on? Bambu Handy on your phone? Browser on a Laptop? Tablet? Phone? etc.
- Your internet connection isn’t great, and trying to monitor prints remotely has caused issues, such as password problems and difficulty sending prints to the printer.
-
- What does this have to do if you are in LAN-only mode? LAN-Only cuts you off from the Internet and all your traffic is local to your Local Area Network(LAN). This is the whole point of LAN-only mode.
- You noticed the camera settings in the wiki show more options than what’s available in your studio software.
-
- @lkrause addresses this above.
- You’re asking if there’s a way to extend the viewing time in LAN mode so you don’t have to press play so often.
-
- Viewing time is not constrained. If you’re seeing a disconnect, there is a problem with the connectivity between your printer and your viewing device. This is a known weakness in Bambu LAN-only mode and there is a post on this last week that goes into great details. When is this network logon/rebind PITA going to stop?
- You also want to understand why the settings in the wiki differ from what you see in your studio.
-
- @lkrause addresses this above.