Tape at the end of spool

[Spoon]

@SupportAssistant

Please note that the tape issue has happened for a small number of spools in a batch. The issue has been solved as described in the previous post, with the tape being correctly applied.

I think that you have been given the incorrect info on this.

It’s still happening and even new people to your printers are experiencing problems but think it’s something else…

AMS not swapping to same color when empty

Hello, I purchased the Bambu P1S with the AMS 1 month ago. I’m loving it. However, I cannot figure out how to get it so swap to the same color if the color runs out. I added 2 identical black Bambu PLA filaments into the AMS. I do have the “AMS filament backup” checked in the options. The Filament section shows both the black “Bambu PLA Basic” in the list in different slots (when I asked it to sync). They appear identical here. So as far as I can tell, I have it all setup perfectly. How…