Bambu Lab Community Forum

X1C + 4 AMS + HUB issue

Bambu Lab AMS Troubleshooting

Panamon_Creel January 23, 2025, 8:57pm 10

How to change the order of AMS units General discussions

Well, I finally found the filament and AMS reset. The documentation must be for earlier models of the X1 or something. Mine does not display the “AMS” tab on the initial screen. To get to it now, you have to find the little Reel at the bottom-right of that screen and press on it. That brings up the second screen which allows you to set options for the AMS. The picture above does not show it, but there’s now an option to reset the AMS mapping. Then you then need to turn off the X1 and unplug all …

X1 Series Printers Screen Operation Guide

This guide describes the on-screen operation of the X1 Series.

https://wiki.bambulab.com/en/x1/manual/Connect-AMS-Hub-and-multi-AMS

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled