X1c filament squishing stuck with 0.2 nozzle

[SimEyeSee]

Check out this post:

Reasons to use cool plate or engineering plate?

Preface: I do a lot of small functional prints using a 0.2 nozzle with small layer heights (I really don’t use the 0.4 nozzle much which is why I bought the X1C because of the great prints with a 0.2 nozzle). My parts usually require a brim with a 0.0 Brim-Object Gap to keep the print on the plate. During the design process I will print initially in PLA to refine the design, then use ASA, ABS, PETG, etc for the final print. The smooth print plates do provide better Z height accuracy over the te…