X2D Opinions

[Mason49]

I’m considering buying the new X2D, but before I do, I’m wondering what the best move is. Should I sell my couple months’ old P1S, or just keep it in addition? And on top of that, being new, what do all of you think about it, and are there any huge issues I should be aware of?

[CincinnatiDesigns]

X2D is so nice

My X2D already arrived; I’m surprised they have sent it so quickly. As usual, it is an awesome printer—easy to set up—but make sure you install the bottom of the rear fan properly. It is easy not to snap it in properly, and you will have a gap where air can escape without being filtered. Quality is the best out of all my printers, better than H2C, and this could be due to both-sides cooling. 1.5 mm belts are amazing, and there are literally no VFAs. I’m super happy they finally unlocked cooli…

I suggest reading and contributing to this topic.

There are a few similar ones but this one has been active