Bambu Lab Community Forum

Z rod bushing not flush

Bambu Lab P1 Series Troubleshooting

Lexi April 30, 2024, 7:28pm 2

Z Rod Bearings on P1P Troubleshooting

Has anyone experienced the Z rod bearings on their P1P slipping out of place like the picture below of the left bearing? Left: [signal-2024-02-22-121408_002] [signal-2024-02-22-124304_002] RIght: [signal-2024-02-22-121408_003] [signal-2024-02-22-124304_003]

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled