I got my A1 on December 22, on the 24th it stopped extruding filament. Replaced filament sensor, new extruder gears and new nozzle. Now, I can’t get silk to print with AMS. I can print with any other filament other than silk I have been going back and forth with support, trying to figure this out. …

normal silk works fine! its the problme with the dual silk, becaus it is oval and the extruder cant grab it. I tested it without the ams with external role. It started but during the print it stoped extrude…

Amazon brand eono triple colour ( red gold and blue ) at least 8 mths old

this could work, becaus there you have not the oval problem. But this is a workaround. I think, that original Bambu Filament should work on the A1!

Updated my experience from the last time. Personally I only use Eryone silk for now, It seems reliable enough. Single color silk, dual color, and lots of tri color silk. I have a new dryer and since then it’s been a big improvement. All of those roles have been in the dryer before printing, for two …

I have serious problems with bambulab gold silk and the a1 mini ams light breaking inside the gears of the exteuder… 2 times so far in a multicolor print! Its a silk problem … normal pla has no problems at all. Doesn’t bambulab make filaments that are supposed to be compatible with ams? I find i…

[image] A1: Dual Silk clogs .4 and .6 Troubleshooting I can confirm oval on my dual silk from Bambu. The A1 extruder gears slip on it and fail to extrude - not a clog. See pics below - you can see the gears tear up the surface of the filament, and there aren’t any deep tee…

If the problem is that one maybe you can try this ! [image] A1 - Hack - to print TPU Filaflex 70ShoreA and Pulltruded PET by 3dEvangelist The Problem!I would like to share an observation regarding the production of pultruded PET with a re-creator. The filament diameter tends to vary s…

Hi All, Based on what I can see no one is able to print with dual silk with the AMS but it seems to be working from the external? is that a good summary?:slight_smile: thanks all !

So far yes. It has been better since the last firmware update. It is the worst when the roll is low and light, then it seems like that back tension on the AMS is pulling the filament to tight against the gears of the ams, then causing it to slip and fail.

I have printed triple silk (Sovol) via the AMS, no issues, but I’ve ever used dual.

A1 wont print silk

Bambu Lab A Series

KYZ_Design April 19, 2024, 9:10pm 38

Same issue - filament is oval - gears slip on it