First layer print Failed

[JonRaymond]

Reference

First layer is a hot mess

I have a new P1S. Benchy and a Squishy Turtle from the SD card printed beautifully. I have the supplied textured PEI plate as well as a SuperTack cool plate. I’m using Bambu PLA Basic. I’m unable to successfully print anything from Bambu Studio. The first layer is a hot mess. The outer perimeter lays down nicely, but the infill of the first layer is terrible. It seems to be a problem when the extruder head changes directions. It stops laying down filament, but then gobs it back up on the…

Terrible first experience with the P1S and AMS 2 Pro, help welcome

Hi, I have setup a brand new P1S with ans AMS 2 Pro and so far it has only been a nightmare. I pulled the trigger on this because of all the positive comments on Internet about “it just works” but so far I am truly disappointed. I have been 3d printing for several years so not a total newb. For the moment I have removed the AMS 2 since it does not work. i.e. it is not even able to push filament to the buffer (does not matter which position in the AMS) and this is basic PLA that comes with the …