Very high probability of an ID10T issue here, but I need some suggestions on things to check/possible causes. Like an idiot, I printed a tall skinny model using gyroid infill, the excessive wiggle/vibration caused the model to fall over resulting in a blob of not quite death. Removed the blob, eve…

Also I figured out why, in part I was confused about scarf. There’s no option to set degree [20250320_045334] [20250320_045327]

You need to enable the advanced option toggle and in the settings panel possibly as well if the toggle won’t go green. But more on topic. [17425082010851481177654770787154] Silk Failed. Just failed or my kid only caught it now lucky. It was air printing 34 layers up. Something happened. I’m ch…

Sorry dbl post cell button edit won’t work. Here is a good game for people hehehe. [IMG_20250320_180743] Find what went wrong to make this poor mini jam and air print for 34 layers by just looking at this picture. :grin: And yes. I’m fixing the poor boy now. I’ll post back on computer later and…

I quit. I moved on from fidget spinners and was trying to print a clock as a retirement gift for a coworker. [20250320_181036] I also tried to run 2 separate prints with 3 separate fidgets each in 3 different colors printed by object… out of 6 possible fidgets, I got 2 of decent quality. One prin…

Have you checked these 4 screws by any chance? [image] When I as having issue with the nozzle dragging on my A1, this was the culprit. I kept having prints get snagged and knocked over as well so it’s worth a look. Seems pretty common that these things come out. My A1 Mini never had the issue, bu…

Yes, I made sure I checked the screws were right when I installed the new heating element a few days ago

You “broke the wires to the hot end,” repaired it, now you’re having problems. Take a step back: Your hot end isnt seated properly its not getting proper heat you broke something else in the process. Take a picture of the exposed hot end. Many angles. Take it out, and take another round of pictu…

Well there is a lot of crossing info in this thread now. So I’ll break out the parts that I can solve here: Silk - this spinner - trash. As you can see form my above photo’s in a large batch there will be issues due to the size and the “overhangs” by the time it works on another wheel the silk exp…

So print fidgets in silk (if I do) one or two at a time. Best part about the clock, I restarted the print again, changing nothing and it printed perfectly fine. I don’t like this whole intermittent issue thing. Like why can’t things fail constantly or not fail at all. Ran another print of differe…

I was having issues before the hot end replacement, which obviously caused the situation in which the hot ended needed to be replaced. Also, I have already gone over every screw, belt, idler, clasp, and partridge in a pear tree.

Prints keep getting knocked off plate

Bambu Lab A Series Troubleshooting

FearedByNone March 28, 2025, 10:33pm 59

here is a link to the original thread that i found with solutions toward the bottom. the op is the person that discovered the issues and reported them.