Would it be possible to extend the cable for the P1P control panel?

Bambu Lab P Series
1

Basically I want to orient the printer in a way which would make its control panel difficult to access, therefore an extension cable would be good so I can build a mount for it on my racking. If so, what is the cable called, what should I be looking for or is it proprietary.

2

The wire connection is a JST GH 1.25mm pitch 12 pin connector

display connector
display connector455×572 53.5 KB

Be careful with extending this cable as it will act as an antenna and you may have electrical noise issues.

3

For the small outlay, it’s worth considering the xtouch screen. You’ll be able to remotely mount the screen wherever you want.