Basically I want to orient the printer in a way which would make its control panel difficult to access, therefore an extension cable would be good so I can build a mount for it on my racking. If so, what is the cable called, what should I be looking for or is it proprietary.

The wire connection is a JST GH 1.25mm pitch 12 pin connector [display connector] Be careful with extending this cable as it will act as an antenna and you may have electrical noise issues.

For the small outlay, it’s worth considering the xtouch screen. You’ll be able to remotely mount the screen wherever you want. [image] Added P1P a Touch Screen Bambu Lab P1 Series Hi all, I am working in a P1PTouch screen. [image] It’s using this cheap ESP-32 boards […

Would it be possible to extend the cable for the P1P control panel?

Bambu Lab P Series

RMB November 23, 2023, 1:25pm 3

For the small outlay, it’s worth considering the xtouch screen. You’ll be able to remotely mount the screen wherever you want.